Diy Table Saw Fence Extension. This can be especially useful when working with large pieces of wood that are difficult to maneuver and need additional room. I made mine out of aluminum to cut down on weight, and because i wanted to challenge myse…
The original fence was in two pieces and that made it tricky to line up precisely. Use the factory cut edge of a piece of plywood as a. The auxiliary fence serves as a substitute for the rip fence, extending forward to provide a longer.
I cut the legs to 15 tall, (this will accommodate for the 3 casters and the 2x4 bottom base).
You’ll find it a snap to cut boards to the same length with a sliding, adjustable outrigger stop block attached to your table saw’s miter gauge. That means i’d need at least 48″ to right of blades. It helps support the right side of the plywood when it’s overhanging the front of the saw table. Make your cut and then reset.
